GKTech - V3 4130 HIGH TENSILE OFFSET STEERING RACK EXTENDERS

FAQS

Are these sold individually or as a pair, your price is so much cheaper than the others selling these!?
These are sold as a pair. Ie. the price listed is for a pair. These are a pretty straight forward item to machine up, it's not rocket science.

How does this offset steering rack spacer work?
The offset steering rack spacers screw into your steering rack and move the tie rod end position forward 0.98'' (25mm). It helps reduce steering bind (aka tie rod goes over center). It allows the steering rack to travel an extra 0.74'' (19mm). An extra 0.74'' (19mm) of additional steering rack travel = more lock.

I've installed the rack spacer and I've got a heap of toe in, what happened?
After you have centered your rack (this is CRUCIAL) you may need need to trim your tie rod ends down to counteract the length that you've just put into the length of the rack. Whether you need to trim the tie rods down depends on your setup (Ie. if you've got longer LCA's or aftermarket knuckles you may not need to).

Do NOT trim too much off or else you'll need to get a new tie rod and only trim down once you've centered the rack. Note that the LH side has a larger spacer so it will need the most attention.

What's the difference between this offset steering rack spacer and the non offset steering rack spacer that you sell?
The offset steering rack spacer moves the tie rod end mount forward 0.98'' (25mm) where as the standard non offset steering rack spacer is a direct extension and doesn't relocate the mounting points. The offset steering rack spacer is only needed with aftermarket or modified knuckles where as the non offset steering rack spacer can be used with the standard knuckles.

What is the difference between your V1 and V3 offset rack spacers?
Our older revision had two different sized offset rack spacers, one short and one long, however, we revised the design to have them both at equal length, so that you did not need to center your rack again. We also have added 1/2" internally driven drive bolt sizes for an easy install!

VEHICLE COMPATIBILITY

USER GUIDE(S)