GKTech - 350Z REAR CALIPER TO 240SX WELD ON CALIPER BRACKET

FAQS

Can I still keep my e-brake?
Good question! The 350z rear calipers/rotor setup can be used in conjunction with a Skyline/Z32 rear drum setup. 

How hard are these to fit?
Mechanical and fabrication knowledge is required. If you're not a competent welder, take to someone that is. 

Do the front 350Z calipers also fit?
They do! You'll just need to drill the knuckle hole from 12mm to 14mm and trim your OEM dust shield and you're good to go.

Are any other mods required to fit the 350Z calipers?
Besides the calipers, rotors and the e-brake assembly (if you so wish) it's best going to a large brake master cylinder. the BM57 we sell is perfectly suited to the 350Z Brembo calipers. Depending on the brake lines you have, you may also need to swap to some braided brake lines like the conversion lines that we sell. 

Will these fit my car?
We can only confirm fitment for the vehicles listed above under "confirmed fitment".

I have Skyline (R32, R33, R34) calipers currently, do I need new brake lines?
No, if you have Skyline calipers currently on your car you don't need new brake lines.

I have S-chassis (s14/s15) calipers currently, do I need new brake lines?
Yes, you will require new brake lines with fittings that fit Brembo calipers. We have conversion lines which can be found here;

VEHICLE COMPATIBILITY

USER GUIDE(S)