RB SKYLINE/GT-R HIGH PERFORMANCE ENGINE FAN - 40% MORE AIR FLOW

Will this fit my car?We can only confirm fitment for the vehicles listed above under "vehicle compatibility". If your car is not listed there, then we don't know if it will fit.Do you make these to suit other cars?We only sell the parts listed on our website. If it's not listed on our website, then we don't sell it. Sorry.

What's the advantage of using the GKTech engine fan?We tested the clutch fan on a test vehicle in a controlled environment (on a dyno) with back to back tests and from 194f, it took less than half the time to go from 194f to idle operating temperature. We found the fan pulls 40% more air than the factory RB fan.What modifications are required, is this hard to fit?No modifications are required, simply just remove and refit.

Is there anything else needed for installation?You will need to supply your own clutch pack. Can I install this myself? If so how long will installation take?Yes, provided you have general mechanical knowledge it is straightforward. Installation should take around 45 minutes. However, being a vital engine component we recommend only a trained professional to install this product.

How do clutch fans compare to thermo fans?If you've ever been to the track with thermo fans you know that unless setup with a shroud and correctly, they're useless. Clutch fans with the standard shroud are the way to go.

What's the weight on the clutch compared to the standard item?The standard clutch fan is 430mm's in diameter and coincidentally also weighs 640grams.

What is the clutch fan made of?The clutch fan has a metal center (like the factory unit) and is made of ABS plastic (like the factory unit).

Will I lose any engine power with the fan pulling more air?No, with our dyno tests on the same car within 30 minutes of each test with multiple runs made we actually GAINED around 1% in power with the new clutch fan installed. The cause of this? There was less heat soak and everything was running cooler.

Which way do I install it?The fins on the fan are to taper back towards the engine.