CNC71 - ADAPTADORES DE BLOQUEIO DE DIREÇÃO PARA LEXUS IS200 / IS300 - PLUG & PLAY

Fit up no problem, had the balljoints cut and installed with the tie rods in less than an hour.
they are holding up great so far with a couple hundred miles and a drift event on them!
Put me at -6 camber paired with adjustable uppers, 8.5 degreees of caster with full range of toe adjustment.

Awesome kit and value. I highly recommend getting longer bolts to go through the kit into the spindle. My parts store ball joints came with replacement bolts the same size as factory bolts, but they were hex heads, not flange bolts. I also reccomend getting longer bolts - I used m12 1.25 x 40mm flange bolts from Mcmaster instead of the 35mm long bolts like factory. CNC71 should include these with the kit to replace the old factory bolts that are too short but it's no issue to order some. If you are running 18" wheels you will need to do some serious clearancing and cannot run low at all, but that's just how these cars are, no fault to the aftermarket parts.

Was deciding on these or the drift hq brand, but these fit my is200 great! Gives you alot of lock, camber and increases the track width. Note, will lower the front end, so make sure the raise it a little bit to save the hassle of jacking it back up