Mocal - HD Heavy Duty Oil Cooler Core (HDOC54)

The most popular oil to air coolers are the pressed plate range, which were first made in the late 50's. These coolers, built to our specification since 1965 must rate as the single most commonly used component on racing cars world wide.

The cooler consists of a variable number of aluminium pressed plates forming oil ways and end tanks, the oil ways contain turbulators. These do not only break down boundary layer effects in the flow to obtain maximum heat dissipation without undue pressure drop but also, because they are brazed to both surfaces of the plates, hold them together under pressure. The oil ways are interspersed with aluminium strip louvered and formed into corrugations to provide airways.

Maximum working pressure on the standard range of coolers is 10 bar (150psi) although each cooler is tested to 11.5 bar (170psi) this is adequate for all but the most arduous motoring applications, however some customers prefer a higher pressure rating, for instance where the pressure by pass valve does not provide enough protection as in high rpm in cold start up conditions or on dry sump installations.

Heavy Duty Core

The heavy duty (HD), 12bar (180psi)working pressure version of the cooler is dimensionally similar to the standard cores but has aluminium castings between the plates, on the standard cooler this is the weakest point where they are unsupported by fins or turbolaters, there is also thicker material in some areas. These coolers are about 18% heavier than standard core coolers.

• M22 Ports
• 235 Matrix Core
• Heavy Duty Series Oil Cooler

Available Sizes:

• 19 Row (0.38L Capacity)
• 25 Row (0.50L Capacity)
• 34 Row (0.68L Capacity)